Micro Swiss Brass Plated Wear Resistant Nozzle for Creality K1, K1 Max, CR-M4 Metal Printing speed: 50-100MM/s

Printing speed: 50-100MM/s

Sunlight (in summer) approx

press and apply

Connect the other AMS units in series with additional 6-pin cables

The AMS Heater is easily installed on top of the AMS using a "loosen–swap–tighten" principle in approximately two minutes

Micro Swiss Brass Plated Wear Resistant Nozzle for Creality K1, K1 Max, CR-M4 Metal Printing speed: 50-100MM/sMicro Swiss Brass Plated Wear Resistant Nozzle for Creality K1, K1 Max, CR M4 Dysen er fremstillet af et 360 messingbasismateriale og belagt med TwinClad XT belgning. TwinClad XT er en nikkelkompositbelgning, der er designet til meget lav friktion. Den giver en af de laveste friktionskoefficienter, bedre end nikkel med PTFE co deposit. TwinClad XT belgningen er ogs meget hrd og slidstrk. Hvis du arbejder med slibende kulfiber, rustfrit stl, trfyldte